Emptying The Dust Collecting Drawer En - Abicor Binzel FES-200 W3 Manual De Instrucciones

5 Functional description
5.1 Emptying the dust collecting drawer
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Disconnect all electrical connections.
CAUTION
• Before performing any maintenance and cleaning work, suitable safety measures must be taken.
• Maintenance and cleaning work on the fume extraction system may only be carried out in areas with locally filtered
forced ventilation.
• Check and wear your personal protective equipment.
• The personal protective equipment includes protective clothing, safety goggles, respirator mask Class P3, protective
gloves and safety shoes.
• Nobody without personal protective equipment may stay near the dust collecting drawer when it is being filled with the
separated dust.
1 Remove the knurled nuts from the dust
collecting drawer
Fig. 3 Emptying the dust collecting drawer
Proceed as follows:
 Fig. 2 Functional description on page EN-11
1 Switch off the fume extraction system by turning the rocker switch (11) (0 position).
2 After having switched off the fume extraction system, wait (for approx. 1 minute) until the dust has settled down in the
fume extraction system.
3 Remove the knurled nuts (9) from the dust collecting drawer (8).
4 Carefully pull out the dust collecting drawer (8).
5 Slide the full dust collecting drawer (8) into the dust collecting bag supplied and close the bag.
6 Turn the dust collecting drawer (8) over so that the dust can fall into the dust collecting bag.
7 Carefully open the dust collecting bag and take out the dust collecting drawer (8).
8 Close the dust collecting bag tightly.
9 Clean the dust collecting drawer (8) using a damp disposable cloth.
10Clean the area into which the dust collecting drawer (8) will fit using a damp disposable cloth.
11 Slide the empty dust collecting drawer (8) into the fume extraction system.
12 Lock the dust collecting drawer (8) by screwing the knurled nuts (9) onto the fume extraction system.
13 Dispose of the dust collecting bag and the disposable cloth according to the local regulations.
 12 Disposal on page EN-24
EN - 12
2 Pull the dust collecting drawer carefully
out
FES-200 W3
3 Put the dust collecting drawer in the
dust collecting bag included in the
delivery and close it
BAL.0335.0 • 2019-08-16