Replace The Filter Cartridge En - Abicor Binzel FES-200 W3 Manual De Instrucciones

5 Functional description
3 After having switched off the fume extraction system, wait (for approx. 1 minute) until the dust has settled down in the
fume extraction system.
4 Remove the suction hose from the air intake fitting (6).
5 Close the air intake fitting (6) with the seal plug supplied (7).
6 Connect the compressed air.
 Fig. 4 Filter dedusting on page EN-13
7 Open the valve lever (4) on the compressed air connection.
Due to the compressed air, the cleaning nozzle rotates inside the fine filter cartridge. By moving the tube manually upwards
and downwards, the exhaust fume deposits are completely removed from the filter and the filter is refreshed. The separated
dust is collected in the dust collecting drawer.
8 After having switched off the fume extraction system, wait (for approx. 1 minute) until the dust has settled down in the
fume extraction system.
9 Remove the knurled nuts (9) from the dust collecting drawer (8).
10Carefully pull out the dust collecting drawer (8).
11 Put the separated dust from the dust collecting drawer (8) into the dust collecting bag supplied and close it.
 5.1 Emptying the dust collecting drawer on page EN-12
NOTICE
• The dust collecting drawer (8) must be emptied before and after each dedusting of the filter.
• If the dedusting of the filter has no effect on the suction power, the filter must be replaced.
5.3 Replace the filter cartridge
After longer operating times, the fine dust penetrates into the filter and the filter becomes clogged. Even a dedusting of the
filter cannot remove this dust. The filter must be replaced by a new one.
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Disconnect all electrical connections.
CAUTION
• Before performing any maintenance and cleaning work, suitable safety measures must be taken.
• Maintenance and cleaning work on the fume extraction system may only be carried out in areas with locally filtered
forced ventilation.
• Check and wear your personal protective equipment.
• The personal protective equipment includes protective clothing, safety goggles, respirator mask Class P3, protective
gloves and safety shoes.
• Nobody without personal protective equipment may stay near the dust collecting drawer when it is being filled with the
separated dust.
• It is not allowed to dedust the filter cartridge using compressed air.
NOTICE
• A filter change must be carried out if, after multiple dedusting, a vacuum of > 180 mbar is still reached, and no other
error or reason can be detected.
• This procedure must be carried out when the system is not in operation.
EN - 14
FES-200 W3
BAL.0335.0 • 2019-08-16