Don't Overloadthe Generator - Generac Power Systems GP Serie Manual Del Propietário

Using a generator indoors CAN KiLL YOU iN MINUTES.
Figure8 - Grounding the Generator
Generator exhaust contains carbon monoxide. This is
a poison you cannot see or smell.
NEVER use inside a home
or garage, EVEN iF doors
and windows are open.
Only use OUTSIDE and
far away from windows,
doors, and vents.
2.4.1 GROUNO/NG THEGENERATOR WHEN USED ASA
PORTABLE
This generator has an equipment ground that connects the
generatorframe components to the ground terminals on the AC
output receptacles (see NEC 250.34 (A) for explanation). This
allows the generatorto be used as a portable without grounding
the frame of the generatoras specified in NEC250.34.
SpecialRequirements
There may be Federalor State Occupational Safety and Health
Administration (OSHA)regulations,local codes, or ordinancesthat
apply to the intendeduse of the generator.
Please consult a qualified electrician, electrical inspector, or the
local agency havingjurisdiction:
* In some areas, generators are required to be registered with
local utility companies.
* If the generator is used at a construction site, there may be
additionalregulationswhich must be observed.
2.=/.2 CONNECT/NG THEGENERATOR TO A BU/LO/NG'$
ELECTRICAL SYSTEM
When connecting directly to a building's electrical system, it is
recommendedthat a manualtransfer switch is used. Connections
for a portable generatorto a building's electrical system must be
made by a qualified electrician and in strict compliance with all
nationaland local electricalcodes and laws.
GROUNDING
2.5 DON'T OVERLOAD THE GENERATOR
Overloadinga generator in excess of its rated wattage capacity
can result in damageto the generatorand to connectedelectrical
devices. Observethe following to preventoverloadingthe unit:
* Add up the total wattageof all electricaldevicesto be connected
at one time. This total should NOT be greater than the
generator'swattage capacity.
* The ratedwattage of lights can be taken from light bulbs. The
rated wattage of tools, appliances and motors can usually be
found on a data label or decal affixedto the device.
* If the appliance,tool or motor does not give wattage, multiply
volts times ampererating to determinewatts (volts x amps =
watts).
* Some electric motors, such as induction types, require about
threetimes more watts of power for starting than for running.
This surge of power lasts only a few seconds when starting
such motors. Make sureto allowfor high startingwattagewhen
selectingelectrical devicesto connect to the generator:
1. Figurethe watts neededto start the largest motor.
2. Add to that figure the running watts of all other connected
loads.
The WattageReferenceGuide is providedto assist in determining
how many items the generatorcan operateat one time.
NOTE:
All figures are approximate. See data label on appliance for
wattage requirements.