Set Up - Truper MOTB-2 Manual Del Usuario

• Place the equipment on a dry, firm, flat and leveled surface.
• Connect one end of the suction hose (not included) to
the pump water inlet (A), and the other end of the hose
to the filter (B).
• Set the release hose (not included) to the pump water
outlet (C).
CAUTION • All the connections shall be secured
with the right clamps (D).
CAUTION
• Hoses shall be continuous, with no
twists in their structure. Length of the suction hose shall
not exceed the required length to operate the pump
correctly.
CAUTION • Using a filter is essential (B) to prevent
particles entering into the system and damage the motor.
• Submerge the suction hose end with the filter in the
water source.
8
ENGLISH
A
B

Set Up

C
D