Unpacking Instructions - Fanimation STAFFORD FP8274 Serie Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• One ¼˝ blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to
proper method of wiring your fan (page 10). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in fi nding your place should you be interrupted.
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 18)
Hanger Bracket
Assembly
Motor Coupling Cover
Ceiling Canopy
Fan Motor Assembly
Downrod/
Hanger Ball Assembly
• One wire stripper
• Three wire connectors
(supplied)

Unpacking Instructions

Canopy Screw Cover
Assembly
Assembly
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
on
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
Fan Motor Assembly
Hanger Bracket Assembly
Downrod/Hanger Ball Assembly
Ceiling Canopy
Canopy Screw Cover Assembly
Motor Coupling Cover Assembly
Light Plate Assembly
Socket Plate Assembly
Blade Holder Set
Blade Set
Glass Assembly
Light Bulbs
Hand Held Remote
Receiver Unit
Light Plate Assembly
Socket Plate Assembly
Glass Assembly
4
Materials
Wire Size A.W.G.
• Hardware bag:
– Eleven ¼˝-20 screws
with lockwashers
(blade holder to fan motor hub)
– Sixteen
3
screws
(blade to blade holder)
– Fiber Washers
– Bag Assembly Safety Cable
– Wire connectors
Blade Holder Set
Receiver
Hand-held
Unit
Remote
Light Bulbs
Hardware Bag
14
12
/
˝-24 washer-head
16
Blade Set

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido