Battery Replacement - Tripp-Lite SmartPro Serie Manual Del Propietário

Basic Operation

Battery Replacement

Battery Replacement Door: Under normal conditions, the original battery in your UPS
will last several years. Battery replacement should be performed only by qualified service
personnel. Refer to "Battery Warnings" in the Safety section. Should your UPS require
battery replacement, visit Tripp Lite on the Web at http://www.tripplite.com/products/
battery-finder to locate the specific replacement battery for your UPS.
1
2
3
UPS and Battery Recycling
Please recycle Tripp Lite Products. The batteries used in Tripp Lite products are sealed
Lead-Acid batteries. These batteries are highly recyclable. Please refer to your local codes
for disposal requirements.
You can call Tripp Lite for recycling info at 1-773-869-1234.
You can go the Tripp Lite Website for up-to-date information on recycling the batteries or any
Tripp Lite product.
Please follow this link: http://www.tripplite.com/support/recycling-program/
14-12-046-93338B.indb 8
continued
Telephone/Network Protection Jacks: These jacks protect your
equipment against surges over a telephone/network data line.
Connecting your equipment to these jacks is optional. Your UPS will
work properly without this connection.
Not compatible with PoE (Power Over Ethernet) applications.
Fan: The fan cools the UPS's internal components. It operates only
when the UPS is in battery backup mode, is charging its batteries or is
carrying a heavy electrical load.
Input Breaker (SMC1500T only): Protect your electrical equipment
from overcurrent draw from the UPS load. If this breaker trips, remove
some of the load, then reset it by pressing the breaker in.
1
Carefully pull the front panel away from the UPS.
Place front panel on top of the unit. Remove the battery
support bar.
2
Remove old batteries.
Carefully pull the batteries from the UPS and disconnect them.
3
Connect new batteries.
Connect the new batteries in exactly the same manner as the old
ones: positive (red) connectors together and negative (black)
connectors together. Carefully push batteries back into the UPS.
4
Reassemble UPS.
Reinstall the battery support bar and replace the front panel.
8
12/23/2014 10:22:03 AM