Gram FV 120 Serie Manual De Utilización página 13

Take a balance with the capacity of 200g for example.
• Plug in and pre-warm your balance at least 30 minutes before calibration.
• Turn on the balance.
• Press the
• Press the
• The message
• Press the
value, the display will show "SAVE---".
• Press the
• The display will show
• Press the
• The message CAL--- will be displayed about 3 seconds, then the display
will show CAL dn.
• Put an external calibration weight of 100g (must be OIML Class F1) on
the centre of the pan, then close the doors, the balance will calibrate the
weight and display CAL---.
The message CAL up will be displayed after calibration is over, remove
•
the weight on the pan and close the door. The display will show CAL...,
then will be CAL end and return to weighing mode.
Note: If the tolerance between the displayed value and the weight value is
no more than 0.0001g the balance is well calibrated. Otherwise, repeat the
calibration steps until it is well done.
key then the
key to select C1 and
C1" 01§ will be displayed.
※
till display C9, then press the
key, the display will show "SAVE-end", the setup is finished.
0.0000 g §.
※
key, the display will show CAL-in.
key.
to select 01.
key to store the set
13