Operation; Maintenance; Environmental Protection; Warranty - Mettler Toledo EasyClean 200e Guía De Configuración Rápida

en
20
1 Terminal for N and L wires
For details on function tests and programming of the
EasyClean 200 e , please refer to the instruction manual.
5

Operation

When switching the device on every day and when a new
shift starts, check whether the supply of compressed air,
rinsing water and electrical power are correct, that the
wastewater drain is connected, and that the detergent solu-
tion container is full. For details on operation and failure
modes, please refer to the instruction manual.
6

Maintenance

To remove dust, dirt and stains the external surfaces of the
EasyClean 200 e can be wiped with a soft, damp cloth. If
necessary a mild detergent can also be used. For cleaning
of the interior you may use a dry cloth or filtered compressed
air that is free of oil and water (pressure < 6 bar).
a
Caution: The exterior of the EasyClean 200 e must not be
cleaned with any solvent containing acetone. The interior of
the unit must not be cleaned using liquid or a damp cloth.
When cleaning the pump piston and the cylinder, take care
that the surfaces do not become scratched or damaged.
7

Environmental protection

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
8

Warranty

On manufacturing defects, 12 months after delivery.
EasyClean 200 e
30 404 677 B
–
© 07 / 18 Mettler-Toledo GmbH
Printed in Switzerland
EasyClean 200 e