Connections; For Models Without A Sony Amplifier - Metra 99-5849CH Instrucciones De Instalación

For models without a Sony amplifier:

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• If equipped with a factory subwoofer, connect the Blue/White wire to the amp turn on wire.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Tape off and disregard the following (5) wires, they will not be used in this application:
Brown, Green, Green/Black, Purple, Purple/Black
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.

CONNECTIONS

From the 5849 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
• Tape off and disregard the following (1) wire, it will not be used in this application: Blue
• For models equipped without SYNC
"FROM 3.5" to the audio AUX-IN jacks from the aftermarket radio.
• Disregard the Red and White RCA jacks labeled "RSE/SYNC
in this application.
Continue to 3.5mm jack - steering wheel control retention
® : Connect the Red and White RCA jacks labeled
®
/SAT", they will not be used
REV. 9/27/2019 INST99-5849CH
7