Cables: Sfic - Schlage Kryptonite KS Serie Manual De Instrucciones

SFIC CYLINDER
1
2
3
4
5
6
7
PARTS
ITEM
1. Dust Cover Screws
2. Dust Cover
3. Cylinder
4. Throw Member
5. Lock Head
6. Washer
7. Throw Member Mounting Screw KZ34DC0
12

Cables: SFIC

ASSEMBLY INSTRUCTIONS
1. Place throw member (as shown) onto
installation tool. Insert throw member and instal-
lation tool into cylinder hole of lock head.
(Figure 1)
Note: Alignment tab must be
positioned as shown.
Figure 1
2. Rotate the lock head, holding the installation
tool and throw member in place. Drop the
washer into the locking hole. (Figure 2)
Note: Washer must be positioned as shown.
Figure 2
3. Drop the throw member mounting screw into
the locking hole and tighten using a 3mm Allen
Wrench. (Figure 3) Remove installation tool.
Figure 3
ITEM #
KZ36EB0
4. Insert and lock cylinder in place with control
KZ36EA0
key, then remove control key. (Figure 4)
Figure 4
KZ33CA0
KZ33DB0
5. Place the dust cover in position. (Figure 5)
Figure 5
6. Insert the dust cover screws and tighten with a
Alignment Tab 2mm Allen Wrench. (Figure 6)
Figure 6
Installation Tool
The cable lock is now assembled.
CHECK FUNCTION: Close and lock cable. Turn
key 90 degrees clockwise to unlock cable.
Product is only available with Key Retaining
function.
Washer
NOTE ON CYLINDER PINNING
Conventional Key-In-Knob and SFIC service
manuals are available from Schlage for
additional information on cylinder pinning, key
cutting, and key control procedures.