Schlage Kryptonite KS Serie Manual De Instrucciones página 9

5. Apply grease to the stamped face of the
locking cam. Holding shackle closed, (making
sure locking ball bearings stay in side pockets)
use small pliers and insert locking cam into lock
body. (Figure 5)
Note: Make sure tab on key retaining locking
cam fits into tab cutout in lock body.
Figure 5
Tab
Tab cutout
6. Place throw member (as shown) and steel
retainer plate onto installation tool. (Figure 6)
Note: Make sure that letters on steel retainer
plate are face down.
Figure 6
Retainer Plate
Throw Member
Letters
7. Hold installation tool as shown. Drop lock over
installation tool and insert into center hole of
lock body. (Figure 7)
Note: Alignment tab must be positioned as
shown.
Figure 7
Alignment Tab
8. Turn lock over and lift installation tool until
alignment tab clears lock. Turn installation tool
clockwise to unlock shackle. (Figure 8)
Figure 8
9. Remove installation tool and place in opposite
side of lock body so the alignment tab falls into
place. This will hold throw member and steel
retainer plate in place. Hold installation tool in
place and turn lock over. (Figure 9)
Figure 9
10. Move shackle to one side. Insert steel
retainer plate screw in shackle hole and tighten
with a #2 Phillips Screwdriver. (Figure 10)
Remove installation tool.
Figure 10
11. Insert and lock cylinder in place with control
key, then remove control key. (Figure 11)
Figure 11
12. Slide bumper onto bottom of lock body.
(Figure 12) Lock is now assembled.
Figure 12
Check Function: Close shackle. Turn key 45
degrees clockwise to open.
NOTE ON CYLINDER PINNING
Conventional Key-In-Knob and SFIC service
manuals are available from Schlage for
additional information on cylinder pinning, key
cutting, and key control procedures.
Cylinders can be rekeyed using existing Schlage
cylinder components and/or pin kits.
Padlocks: SFIC 9