Seac Sub ICARO Manual De Usuario página 37

ENGLISH
The transport handle on the backpack of
ICARO TECH must be placed on the neck of
the valves (see illustration number 13) as an
extra safety measure to prevent the tank from
slipping if the connection straps should not
hold properly. In the case of the ICARO stabi-
lizing jacket, the handle is sewn directly onto
the bag.
Drawing 13
Handle on the valves
Attention!
The transport handle supplied on the ICARO
TECH and ICARO jackets is only for transporting
the stabilizing jacket on the surface and without
the tank or as an extra anti-slip safety measure
once the jacket has been assembled onto the
tank itself. The transport handle must never,
under any conditions, be used as a means of lif-
ting the assembled SCUBA gear.
At this point, put on the stabilizing jacket and,
maintaining an erect position, try to lower the
nape of your neck backwards: if the position
is correct, you should have no problem carr-
ying out this operation. At the same time,
check that the base of the tank does not
move too far downwards, disturbing your
movements. We advise you to mark a fixed
reference point on the tank- for example, a
38
strip of adhesive tape or painted line - so that
you can always reassemble your stabilizing
jacket in the correct position. This procedure
may seem excessive, but it will guarantee
you the correct use of the stabilizing jacket
for all future dives. Remember that the bloc-
king system is designed to be assembled
onto any single cylinder with no additional
accessories required.
Attention!
These special straps guarantee that the stabili-
zing jacket will accommodate any single cylin-
der with a minimum diameter of 140 mm and a
maximum of 220 mm. (18 litre steel tank). Or for
the use of a 10 + 10 liter twin cylinder tank.
Attention!
If you use the stabilizing jacket with a twin cylin-
der assembly, you must apply the supplementa-
ry kit. Seac code S103006 (see illustration num-
ber 14).
Drawing 14
Assembled twin cylinders kit
Assemble the connection hose with the rapid
attachment to a low pressure outlet of your