Preparation Of Premises And Machine Installation - Enofrigo DOGE ISOLA Manual De Instrucciones

The manufacturer accepts no liability for damages caused by operations that have been performed incorrectly.
10.1 Procedures for unloading the machine by means of a forklift truck
Step 1 unload the machine, still packed, from the lorry with the utmost caution
Step 2 rest the machine gently on the ground
Step 3 remove the packaging and gently raise the machine with the forklift truck,
being careful not to damage it , until the pallet can be removed
Step 4 rest the machine gently on a flat uniform surfaces as near as possible to its final position

11 PREPARATION OF PREMISES AND MACHINE INSTALLATION

The room in which the machine will be installed, like the various existing systems, must comply with current
local regulations and technical specifications.
Position the machine in a dry well-ventilated place in compliance with the local technicalhealth regulations. In
particular:
• Avoid positioning the machine near sources of heat (radiators, ovens, burners etc.) or draughts. If this is not
possible, the following minimum distances must be observed: 50 cm from coal or oil cookers and 50 cm from
electric/gas cookers.
• Avoid the risk of power failures by ensuring that the machine is not exposed to direct sunlight.
• Make sure that the machine ventilation apertures are not covered.
Carefully unpack the machine, removing the main cardboard box and then all the packaging
protection materials.
Once you have removed the packaging, check that the machine is in perfect condition and notify the
manufacturer or authorised dealer of any damage found within 48 hours from receipt of the goods.
For installation of the machine, take account of the data given on the identification plate and the overall
dimensions (see chapter n° 5 and n° 6).
A free space of approximately 50 cm must be left around the machine for operation and maintenance.
N.B. = Connect the electric supply cable to a suitable plug (this operation must be done by a qualified
technician)
You are strictly forbidden ti use the machine in places where there is the danger of explosion or fire due
to the presence or development of dust, gas or explosive or flammable mixtures.
CT68900002 Rev.0 09-13
24