Environmental Protection; Technical Specifications - Metabo KHE 2650 Manual Original

f 11. Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For a complete range of accessories, see
www.metabo.com or the main catalogue.
12. Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
If you have Metabo electrical tools that require
repairs, please contact your Metabo service centre.
For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.

13. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline
2002/96/EC on used electronic and electric
equipment and its implementation in national legal
systems, used power tools must be collected
separately and handed in for environmentally
compatible recycling.
f

14. Technical Specifications

Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
P = Rated input
1
P = Power output
2
n = No-load speed
1
n = Load speed
2
ø = Maximum drill diameter
max
s = Maximum impact rate
max
W = Single impact force
S = Impact performance
m = Weight
D = Collar diameter
b = Drill chuck chucking capacity
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a = Vibration emission value
h, HD
(hammer drilling into concrete)
a = Vibration emission value
h, Cheq
(chiselling)
a = Vibration emission value
h, D
(drilling into metal)
K = Uncertainty (vibration)
h,HD/Cheq/D
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in EN
60745 and may be used to compare one tool with
another. It is also suitable for a provisional estimate
of the vibratory load.
The specified vibration level applies to the main
applications of the power tool. However, if the tool is
used for other applications, with different
accessories or is poorly maintained, the vibration
level may vary. This can considerably increase the
vibratory load over the entire working period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not
actually doing the job. This can considerably reduce
the vibratory load over the entire working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
service the tool and the accessories, keep hands
warm, organise work patterns.
A-effective perceived sound levels:
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty (noise level)
pA WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~
Alternating current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
ENGLISH en
11