Dispenser Installation - Oki LD610 Guía De Instalación De Accesorios

disPenseR insTallaTion

To install the optional dispenser
1. First, follow the instructions in the Removal of the Bottom
housing Cover section.
2. Turn over the printer in upright position. Pull the cover open/
close latches on both sides of the printer toward you to
unlock the Top cover, and then open the Top cover. Remove
the lower front cover by pulling the bottom slightly away
from the printer and lifting it upward.
3. Before installing the dispenser kit, open the Pressure
bracket by lifting upward and outward as shown.
4. Attach the latches of the dispenser kit onto the holes
located below the two sides of platen roller of the printer.
Close the top cover, close the Pressure bracket by pushing
it in until it locks into place, then turn the printer over again,
with the main PCB facing upward.
note: Be sure to keep the cable off to the side during
installation.
Pressure
bracket
2
1
Hole and latch
7