Media Installation And Removal; Roll Media Installation Procedure - Oki H2P-74S Guía De Consulta Rápida

Media installation and removal

Roll media installation procedure

The installation method of the scroller flange varies with the type, weight and take-up direction of the media. See the tables
below to install the scroller flange correctly.
Flange spacer
1
Put the media on the table.
If you want to use a dolly, contact us. We have a
recommend product.
2
Insert the scroller shafts into the paper tube.
Note
- Adjust the position of the roller shaft so that the roll
spacer is positioned at the center of the media roll.
3
Install the scroller flange into each end of the
media roll.
(1) Insert the scroller flange into each edge of the paper
tube.
Scroller flange
6 6
General media
Required
Roll spacer
Scroller shaft
Vinyl chloride media
Not required
(2) Insert the flange spacer between the scroller flange
and the media roll.
(3) Push the scroller flange until it stops and turn the handle
clockwise until the flange is fixed to the paper tube.
Scroller flange
Handle
(4) Remove the flange spacers.
Flange spacer