To A Digital Telephone System; To An Audio Recording Device; Using Your Clearone - Gentner ClearOne Guía De Usuario

Figure 9
Connecting to a Digital
Telephone System
Before connecting your ClearOne,
verify that you have digital telephone
service. If you have digital (PBX)
telephone service, you need a digital-to-
analog telephone line converter. For
more information, contact Gentner
technical support.
To connect your ClearOne to a
digital telephone system:
1. Refer to Figure 9 to connect your
ClearOne to a digital telephone system.
2. Set the ClearOne base unit on a table
or desk in the middle of your
conference area.
3. Connect the digital-to-analog
converter by following the converter's
installation guide. Use the proper
impedance setting.*
4. Plug the RJ11 telephone cord from
the ClearOne power supply into the
converter's telephone jack.
5. Plug the RJ45 base unit cable in to
the ClearOne base unit.
10
1 2 3
ON OFF
4 5 6
FLA SH SHIFT
7 8 9
RE DIA L MUTE
* #
0
6. Plug the converter's power cord into
a standard 120-volt electrical outlet. If
the outlet is controlled by a wall
switch, turn it on. The ClearOne plays
a sequence of self-test tones.
7. Lift the telephone handset. Turn on
the ClearOne and listen for a dial tone.
If a dial tone is present the unit is ready
for operation.** Turn off the
ClearOne and hang up the handset.
8. To make a call, lift the telephone
handset and dial on the telephone
BEFORE turning on your ClearOne.
After dialing, turn on the ClearOne by
pressing the ON/OFF button. Leave
the telephone handset off the hook
during the call.
9. To disconnect the call, replace the
telephone handset.
* The digital-to-analog converter has a
four-position switch for impedance
matching. Your setting depends on the
kind of telephone to which you are
connecting. Refer to the converter's
installation guide to determine the
setting.
** If you do not hear a dial tone,
consult your digital-to-analog
converter's installation guide.
Figure 10
Connecting to an Audio
Recording Device
Your ClearOne has an RCA jack so
that you can record your conference
calls directly with a tape recorder or
other audio recording device. Use the
appropriate cable for your recording
device.
To connect your ClearOne to an
audio recording device:
1. Plug one end of the recorder cable
into the RCA jack on your ClearOne
base unit.
2. Plug the other end of the cable into
the recorder's Line In jack.
Using Your
ClearOne
Once you set up and register your
ClearOne Conference Phone, you're on
your way to effortless and convenient
conference calling.
Why is making a conference call
different with your ClearOne? Because
ClearOne is the only conference phone
available with Express Conference™.
With the simple push of one button,
you can be instantly linked to
Gentner's premium conference calling
service. Our conference call operators
take it from there. All you do is simply
push the button.*
*Express Conference is available only in
the US and Canada.
11