Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Do not overstress your tool.
Of course, you will only achieve optimal work results within the
performance range for which the machine is designed! There-
fore, avoid making the infeed too large! Do not misuse the
machine, and do not use it for work for which it is not intended.
Always be prudent and attentive!
Observe the machine during work and proceed sensibly. Do not
use the machine if you are distracted, tired, or if you have con-
sumed alcohol.
Handle the connecting cable with care!
Protect the connecting cable from heat and sharp edges, and
lay the cable so that it cannot be damaged. Do not pull on the
cable to disconnect the plug from the socket outlet, and do not
lift the device by the cable. Ensure cleanliness: Protect the
cable from grease and oil!
Clean thoroughly after work!
Disconnect the mains plug!
Always unplug the mains plug when not in use, before mainte-
nance, when changing tools, cleaning or repairing! Removing
the chips is also a part of cleaning!
Carefully read the operating instructions before use and keep
them in a safe place!
Contents
Legend (Fig.1)
1. Main spindle
2. Lathe chuck
3. Turning tool holder
4. Rotating centre
5. Flange surface for milling unit
Page
6. Sleeve
16
7. Clamp screw for sleeve
16
8. Tailstock
17
9. Sleeve adjusting handwheel
18
10. Handwheel for leadscrew
18
11. Clamp screw for tailstock
18
12. Leadscrew
18
13. Adjusting handwheel for top slide
19
14. Top slide
19
15. Support
19
16. Cross-slide
19
17. Adjusting handwheel for cross-slide
20
18. Clutch switch for automatic feed
20
19. Drive gearbox cover with speed table
20
20. Switch for anticlockwise rotation - stop - clockwise
rotation
20
21. Main switch
20
22. Function display
21
23. Control
21
24 Hollow hexagon wrench
21
25. Lathe chuck wrench
21
26. Chuck guard
21
22
22
23
23
23
23
23
23
24
24
24
24
24
24
25
25
126
- 17 -
Publicidad
Capítulos
Tabla de contenido
