Fitting; Preliminary Preparation And Checks - Honda UMS425E1 El Manual Del Propietario

FITTING

HANDLES
The handle [1] must be installed
on the transmission tube with the
3 screws and washers supplied
using the Torx wrench [2].
Secure the handle in the most
comfortable position for use.
Fitting is to be performed using
the tools in the kit supplied with
the appliance.
[2] Spark plug wrench/Torx wrench
[A]
NYLON LINE CUTTING HEAD
1. Block the rotation of the shaft by
inserting the hexagonal wrench [3] in
the appropriate hole [4].
2. Tighten the nylon head on the shaft,
by turning it counterclockwise.
COMPLETE GUARD
Your grass trimmer is supplied with
a guard [5].
1. Install the guard on the machine
with the two screws and washers
supplied with the Torx wrench
[2].
2. Pull down the cover [6] on the
front of the protector.
[5]
Never use the grass trimmer without its debris shield.
4 EN
A1 A4
B3 C11 D3
SAFETY
[2]
[3] Hexagonal wrench
[A]
765 mm
[4]
[3]
[2]
[5]
[6]
PRELIMINARY PREPARATION
AND CHECKS
FILLING THE FUEL TANK
[1]
The pressure inside fuel
tanks may increase when
the ambient temperature
rises.
The cap should be
removed with care to avoid
any splashing of fuel.
Fuel should be stored in a
cool place, for short
periods of time, and must
never be left in direct
sunlight.
Tank capacity
Recommended fuel
CAUTION:
• Clean the fuel tank cap and its edges to prevent foreign bodies
from entering the tank.
• Fill the fuel tank with a suitable funnel or a jerrycan with a suitable
spout.
• For easy filling, place the machine in the operating position.
• Make sure that the machine remains in a stable position
throughout this operation so that it does not fall over.
Petrol is extremely flammable and, in some circumstances, it
is explosive.
Fill the fuel tank in a well ventilated area with the engine
switched off.
Do not smoke and avoid any flames or sparks in the area where
filling is performed and where the fuel is stored.
Do not overfill the fuel tank (the fuel level must be below the
filler neck).
After filling the tank, make sure that the tank cap is correctly
fitted.
Take care not to spill fuel during the tank filling operation.
Petrol splashes or vapours could catch fire.
Make sure that any spilled petrol has evaporated and that
vapours have dispersed before starting the engine.
Avoid direct contact of petrol with the skin and do not breathe
the vapours.
KEEP FUEL OUT OF REACH OF CHILDREN.
FUEL CONTAINING ALCOHOL
If you intend to use fuel with alcohol, ensure that its octane number
is at least as high as that recommended by Honda (86). There are
two types of fuel/alcohol mixtures: one contains ethanol and the
other methanol.
Do not use mixtures containing more than 10% ethanol, or fuel
containing methanol (methyl or wood alcohol), which do not contain
cosolvents, or corrosion inhibitors for methanol.
In the case of a mixture containing methanol with addition of
cosolvents and corrosion inhibitors, limit the proportion to 5% of
methanol.
NOTE: The guarantee does not cover damage caused to the fuel
system or engine performance problems resulting from the use of
fuel containing alcohol. Honda does not give its approval to the use
of fuels containing methyl alcohol since their suitability is not yet
proven.
B3 C12
SAFETY
0,58 l (580 cc)
Premium unleaded