koban KP 2203 Manual Del Usuario página 38

KP 2203
Phase digital power clamp meter
kW / PF
1. Active Power, Power
Factor Measurement Button.
Press button to measure
kW / PF
Active Power and Power Factor
in measurement mode. Then the
LCD shows Active Power reading
in the primary display and Power
Factor reading in the secondary
display.
kVA
2. Apparent power,
kVAr
Reactive Power measurement
button.
Press button to measure
kVA
kVAr
Apparent Power and Reactive
Power in measurement mode.
Then the LCD shows Apparent
Power reading in the primary
display and Reactive Power
reading in the secondary display.
kWh
3. Active Energy, Time
TIME
Measurement Button.
Press button to measure
kWh
TIME
Active Energy in measurement
mode. Then the LCD shows
Active Energy reading in
the primary display and
measurement time of the Active
Energy in the secondary display.
Σ
4. Power Summation
Button.
Press button to sum
Σ
up the measured value of
current one phase in three
phase measurement mode; then
measure the second phase and
Instructions manual | 38
press the button to sum
Σ
up again; press the
button for the third
Σ
phase after you getting the
measured
value of the third phase on
the display. So the meter will
calculate the sum in this three
phase system automatically, you
will rotate the selector to ∑W at
one time, then the display shows
the total power value.
V / Hz
5. Voltage Measurement
Button.
Press button to measure
V / Hz
voltage of the circuit and display
the measured value in the LCD
display.
A
6. Current Measurement
Button.
Press button to measure
A
current of the circuit and display
the measurement value in the
LCD display.
RS232
7. Data Transmit Button.
Press button to transmit
RS232
measured data to a computer by
special interface cable, you can
record current measured value
and print reports and data trend
curve drawing.
Before press the
to transmittal measured data,
you must connect RS232C
interface cable to the clamp
www.grupotemper.com
button
RS232