Bestway SaluSpa HYDROJET Manual De Instrucciones página 10

Draining the Spa
NOTE:
Drawings for illustration purposes only. May not reflect actual product. Not to scale.
1.
6.
10.
Cleaning the spa
NOTE: DO NOT use hard brushes or abrasive cleaners.
DEFLATION
P61726ASS18
HYDROJET PRO
Spa Repair
For Spa inflatable cover
If the spa is torn or punctured, use the provided heavy-duty
repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation.
WARNING: DO NOT DRY RUN THE HYDROJET SYSTEM.
Dry running the HydroJet System causes permanent damage that is not covered by the
manufacturer's warranty.
303021212340_14x21cm_54139;54296_20季美规HydroJet SPA说明书_英
2. 3.
P00261
P6575ASS16
7. 8.
NOTE: Lift up the spa
when there is only a little
water left. Damages to the
handles are not covered
under the warranty.
11. 12.
Detergent residues and dissolved solids from bathing suits and chemicals may build
up on the spa walls. Use soap and water to clean the walls and rinse thoroughly.
P61725ASS18
P61725ASS18
P61726ASS18
For Spa Liner
If the spa is torn or punctured, use the provided PVC repair patch and glue (not
included) following these steps:
1. Clean and dry the area to be repaired.
2. Cut the provided PVC patch to appropriate size.
3. Use glue (not included) to coat the one side of the newly cut patch. Make sure the
glue is evenly distributed.
4. Wait for 30 seconds and then place the cut patch with glue over the damaged area.
5. Smooth out any bubbles of air that may be trapped underneath, and press firmly for
two minutes.
6. Wait 30 minutes before inflation.
7. The product is once again ready for use. Repeat this process should further leaks
occur.
4.
P00217
P61587ASS17
9.
13.
2.
P61727ASS18
10
5.
P61813ASS18
NOTE: Twist and pull out the
Jet Nozzle, and turn the spa
upside down to dry the water
pipe.
Cover