Bestway SaluSpa HYDROJET Manual De Instrucciones página 6

Pump Test
GFCI Test
1. Plug the GFCI into a power outlet, the indicator turns red.
2. Press the test button, the indicator turns off.
3. Press the reset button, the indicator turns red.
4. Press the "On/Off" button for 2 seconds, your pump is ready to use.
WARNING: The GFCI plug must be tested before each use to avoid risk of electric
shock.
WARNING: Before inserting plug into a power outlet, make sure the current rate of
the power outlet is suitable for the pump.
ASSEMBLY
NOTE: Only the Hydro-Jet Pro SPA has the massage system button. When inflating,
you will notice that air will be expelled from the area where the air hose connects to
the pump, this is normal and prevents damage due to over-inflation.
NOTE: Do not use an air compressor to inflate the pool.
NOTE: Do not drag the pool on rough ground as this may cause damage to the pool liner.
NOTE: Inflation time is for reference only.
Air Valve Check
Always check the air valve carefully before inflation to ensure
there is not an air leak. If the air valve is loose, use the
provided wrench to fasten the air valve following these steps:
With one hand, hold the backside of the air valve from the
inner side of the spa wall and turn the wrench clockwise.
NOTE:
1. Do not over tighten.
2. Do not adjust the air valve connector when
the spa is in use.
303021212340_14x21cm_54139;54296_20季美规HydroJet SPA说明书_英
6