Installation - Omcan PE-IT-0024-S Manual De Instrucciones

Installation

Installation must be executed by qualified personnel in compliance with local and national regulations.
OVEN POSITIONING
Ensure that the oven is put on a stand with the suitable carrying
capacity and that is flat.
After unpacking the oven from its packing, position it in prepared
location, taking into account the minimum distances.
Remove possible protections in polystyrene and take off the
protecting film (F) avoiding to use tools which can damage the
surfaces.
EQUIPMENT HOOK-UP
Electrical connection
The oven is not provided with power supply cable. When connecting the appliance electrically, an automatic
RCD must be interposed with an opening distance between contacts of at least 3 mm. To connect the
appliance electrically it is essential to proceed in the following way:
• Remove the right side panel.
• Connect to the terminal block the power cable.
The power supply cable must be of H07-RNF type, with approved minimum cross section as prescribed by the
specific directive.
The electrical outlet must be easy to access, no moving should be necessary.
The electrical connection (plug) must be easily accessible, also following oven installation.
The distance between the machine and the socket must be adequate to not cause tension in the power supply
cable. In addition, the cable must not be located beneath the machine support base.
If the electrical power supply cable is damaged, it must be replaced by the technical assistance service
or by a qualified technician to prevent any risks.
GROUND CONNECTION
It is mandatory that the electrical system is equipped with a ground connection.
The appliance must be part of an equipotential system. The connection is done on terminal
marked with symbol which you will find near the cable clamp. The section of the equipotential
wire must be at least 10mm2. The equipotential symbol is showed in the following figure.
6