Technical Data And Drawings; Electrical Data; Positioning; Regulations, Technical Standards And Specifications - Lotus MFV-78ET Guia Para La Intalación E Instrucciones De Uso

página de 27

/ 27
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

The data plate is attached to the lateral panel (see drawing electrical connection point) and contains all the information

necessary for connection.

DIMENSIONS

MODELS

80x68,2x57h

MFV-78ET

80x68,2x57h

On positioning the appliance, ensure that it is perfectly levelled. Small adjustments can be made by screwing the

adjustable feet up or down. The master switch or the socket point must be in proximity to the appliance and easily

accessible. It is advisable to place the oven under an extractor hood to ensure rapid elimination of steam. If the

appliance is placed near a wall or partition, kitchen furniture or decorative coverings, etc., these must be fire-proof or

coated with fire-proofing. Local fire prevention regulations must be observed. There must be maximum clearance

between the front edge of the cabinet and the appliance.

REGULATIONS, TECHNICAL STANDARDS AND SPECIFICATIONS

Installation must be carried out in accordance with:

•

current accident prevention legislation;

•

current VDE specifications.

The installation, start-up and maintenance of this appliance must be carried out only by qualified fitters. All installation

operations must be in accordance with current regulations. The manufacturer declines all responsibility for

malfunctioning due to bad or faulty installation.

Attention: international regulations require that a omni pole cut-out device with contact opening of at least 3 mm be

fitted on the wiring leading to the appliance.

The terminal board is situated behind the front panel. The electrical wiring must be no less than HO5 RN F and have a

section suitable for the appliance (see 1.1). Secure the wiring with the wiring clips. Connect the wire ends to their

terminals on the terminal board. The earthing wire must be longer than the other wires so that it will disconnect after the

live wires in the event of the fastener breaking.

The appliance is designed to be connected to a unipotential system. The connecting screw is situated on the back of the

appliance and is identified by an adhesive label.

Attention: the manufacturer cannot be held responsible for, and does not cover in the guarantee any damage resulting

from bad or faulty connections.