User Unit; Keyboard - Daikin FWECSA Manual De Instalacion Y Uso

USER UNIT

The main screen is divided into two parts (which are
referred to below as lt side and rt side) by a vertical line that
separates them.
the following information is contained on the lt side (from
top to bottom and lt to rt):
• room temperature (read by the remote probe on-board
the user unit, or by the probe connected to the I/O board
terminal board, according to the configuration)
• ambient humidity (if there is a humidity probe installed
and configured)
• status symbols:
time slots on
economy function on
dehumidification running
minimum room temperature function
enabled
valve/s open
electric heater enabled/on
SMALL network on RS485 on
serial communication
with supervision system
locked keyboard
EN
3
Controller for units
• alarm signal: symbol and identification of the type of
The following information is contained in the rt side (from
top to bottom)
• identification of the operating mode
• identification of the ventilation status
• identification of the room air temperature SET value
If the unit is OFF the side will be completely covered by the
word OFF written vertically across it.

KEYBOARD

There are 6 keys on the display screen; below are the basic
functions associated with each key.
Mode
OPERATION MANUAL
It is strictly forbidden to reproduce this manual, even partially
alarm overwrite the area normally dedicated to status
symbols.
COOLING mode
HEATING mode
ON/OFF KEY
• switch the unit on/off
• go back to main screen
PRG KEY
Prg
• access to the MENU
MODE KEY
• change operating mode (HEATING/
COOLING)
UP ARROW KEY
• change ventilation values/speed
• scroll through screens
SET KEY
Set
• change SET/VENTILATION mode
• confirm value/return in screen scroll mode
DOWN ARROW KEY
• change ventilation values/speed
• scroll through screens
FWECSA
FC66003946
Rev 00