Tripp-Lite SmartOnline SU1000RTXL2U Manual Del Usuario página 5

200608121 93-2609 SU Owner's Manual.qxd
Installation
Optional Connections
Your UPS will function properly without these connections.
1
Serial Port Connection
Using the serial cable provided, connect a serial
port on your computer to the serial port of your
UPS. See Communications in the Basic
Operation section of this manual to determine
how to monitor and manage your UPS using
this port.
2
External Battery Pack Connection
Check to ensure that the external batteries you
are connecting match the voltage listed on
your UPS's battery connector. Plug either end
of the battery connection cable (supplied with
the battery pack) into the UPS's External
Battery Connector and the other end into the
Battery Output Connector on the rear panel of
the external battery pack.
Since your UPS has internal batteries, external
batteries are only needed to extend runtime.
Adding external batteries will increase
recharge time as well as runtime. Make sure
that each end of the cable is fully inserted into
its connector. Several small sparks may result
during battery connection; this is normal.
10/3/2006
(continued)
5
3:32 PM Page 5
1
SU2200RTXL2U shown
48V/26A
2 SU2200RTXL2U shown