Brother P-touch PT-18R Guía De Usario página 62

TROUBLESHOOTING
Problem
The label is not
printed after pressing
the key.
The label is not
printed correctly.
56
What to do when...
Cause
Has text been entered?
Is the tape cassette installed
correctly, and is there
enough tape remaining?
Is the end of the tape bent?
Is the tape jammed?
Is the tape cassette installed
correctly?
Is the print head clean?
Is Cut Option set to Chain or
No Cut?
Is the rechargeable battery
charged sufficiently?
Solution
A label will not be printed if
there is no text entered.
Check that the tape cassette
is installed correctly, and
that there is enough tape
remaining.
If bent, cut the bent section
of tape with scissors and
thread the tape through the
tape exit slot correctly.
If jammed, remove the tape
cassette, carefully pull out
the jammed tape, and then
cut the tape with scissors.
Check that the end of the
tape passes through the
tape guide, and reinstall the
tape cassette.
When installing a cassette,
press firmly until it clicks into
place.
If not, clean the print head
using a cotton swab or
optional print head cleaning
cassette (TZ-CL4).
When these options are set,
the tape is not fed after
printing the label. Check the
Cut Option setting, or press
the key to feed and cut
the tape.
If the message "Recharge
Battery!" is displayed,
charge the battery.