Publicidad
Idiomas disponibles
Idiomas disponibles
Once assembled, choose the place of use, making sure the
base of the heater is located at least 1.80 m above the
ground.
This heater is not equipped with a device of room temperatu-
re control. Do not use this heater in small rooms that are
occupied by people who can not leave the room by
themselves, unless ongoing monitoring is assured.
3.
Mounting (Figure 1)
Read the safety warnings before starting to mount the product.
We recommend a minimum of 2 people for mounting the base.
Do not connect the device to the electrical supply until it is fully mounted.
Screw the bottom metal tube (E) to the base (F).
Screw the middle metal tube (D) to the bottom tube (E).
Screw the upper metal tube (C) to the rest of the set. Make sure the two holes are at the
top to ensure the heater can be locked in place (Detail 1).
With the help of another person take the heater and then spend all wire and plug from
inside the base.
Insert the heater into the top tube and secure with the two screws provided (Detail 1)
Pull the power supply wire through and fix it to the bottom of the base by the two fasteners
and screws (Detail 2).
4.
Use of equipment
Make sure the power supply corresponds to the details shown on the nameplate:
230 V ~ 50Hz.
Connect the plug into the wall socket.
Using the light switches (Detail 1), you can turn the lamps on and/or turn off manually.
5.
Maintenance
Before carrying out any maintenance work, make sure that the device has been
disconnected from the mains and let the heater cool down for a few minutes.
Switch
Nº Lamps
●
1
●●
1
● + ●●
2
11
Power
1200W
1800W
3000W
Publicidad
