Positioning The Device For Hair Treatment; Connecting The Device To The Mains - Olymp HairMaster Manual De Instrucciones

GB
2 Putting the Device into Operation
2.4 Positioning the Device for Hair
Treatment
When positioning the device for hair treatment, make
sure that:
• the distance D between the head and the two side
arms is equal,
• the distance H from the head to the heater
protective grid of the HairMaster
on all sides.
1. To adjust the lateral position:
– Standing version: Move the device on the
rollers.
– Wall-mounted version: Adjust the swivel arm
and the spring arm in horizontal position.
2. To adjust the height position:
– Standing version: Loosen the fastening screw
(turn in counter-clockwise direction) and
adjust the telescopic tube
height position.
– Tighten the fastening screw
clockwise direction).
– Wall-mounted version: Adjust the vertical
position of the spring arm.

2.5 Connecting the Device to the Mains

1. Perform the following checks before connecting
the device to the mains:
– Check the grounding pin plug (Schuko plug)
and the power cable for damage. Do not
use damaged electrical parts for mains
connection!
– Check the information on the rating plate of the
device. The device must not be connected if
the voltage (V) and the maximum current (A)
indicated on the rating plate do not correspond
to the values of the mains.
2. Plug the grounding pin plug (Schuko plug)
the power cable into a properly grounded and
fused socket (only in standing version).
3. Make sure that the power cable is not exposed to
tensile or compressive forces and that the power
cable is laid in such a way that it does not present
a trip hazard.
®
User Instructions HairMaster
®
is at least 8 cm
to the correct
(turn in
| 751 250 / 09.2017
of
40