Olymp HairMaster Manual De Instrucciones página 62

GB
4 Care and Maintenance
Replacing the radiant heater
®
User Instructions HairMaster
To dismount the radiant heaters:
The radiant heaters are attached to their base by means of spring pressure.
• To dismount a radiant heater, push one side into its base and then
remove the opposite contact block

base
To re-mount the radiant heater:
1. To prevent finger prints being burnt into the radiant heater glass,
never touch it without protective gloves or a clean, soft cloth.
2. To mount the radiant heater, place one side into the base and then
push it down in order to ensure that the contact block on the opposite
side can be inserted into the base.
3. Check for the safe positioning of the contact blocks in the bases.
To re-mount the protective grid of the main heater:
1. Insert the locking pins of the heater protective grid into the two upper
bore holes.
2. Using a screwdriver, lift the heater protective grid and insert the
locking pins
3. Check for the safe positioning of the heater protective grid.
4. Remove the adhesive tape (if required).
To re-mount the heater protective grid of the side arm:
1. First, insert the locking pins of the heater protective grid into the bore
holes located on the side facing the side arm bearing.
2. Next, push the locking pins
bore holes
3. Check for the safe positioning of the heater protective grid.
4. Remove the adhesive tape (if required).
| 751 250 / 09.2017
.
into the bore holes
of the heater protective grid into the
at the end of the side arm.
52

from the radiant heater
.