Cleaning The Rollers And Bearings; Replacing The Filter - Olymp HairMaster Manual De Instrucciones

GB
4 Care and Maintenance

4.1.2 Cleaning the Rollers and Bearings

When the rollers no longer run freely, clean the roller
sleeves and also the roller axles if required.
To dismount the rollers:
1. Place the roller lever
2. Next, remove the roller
To mount the rollers:
3. Place the roller axle on the roller sleeve.
4. Push the roller into its sleeve.
5. Check whether the roller rotates freely.

4.2 Replacing the Filter

The filter prevents dirt particles being absorbed by the
fan.
The filter must be replaced:
• in case of visible heavy soiling,
• if the warning has been displayed,
• at least once a month.
1. The filter cover is attached to the housing by
means of a clamp connection. To open the cover,
use the recessed grip
cover.
2. Remove the filter
the filter case.
3. To close the case, push the cover against it in
such a way that the clamp snaps in (make sure
that the power cable does not prevent the proper
closing of the filter case).
®
User Instructions HairMaster
under the roller axle.
from its sleeve
and lower the filter
and insert a new filter into
| 751 250 / 09.2017
.
50