How To Use - Taurus ALPATEC AC 3100 KT Manual Del Usuario

- Respect the legal provisions regarding safety
distances with other elements such as pipes,
electric conductors, etc.
- Make sure the appliance is level with the floor
- Do not cover or obstruct any openings in the
appliance.
- The plug must be easily accessible in order to
disconnect it in case of emergency.
MOUNTING THE EXHAUST PIPE:
- Stretch the tube, and screw its end to the air
outlet connector.
- The length of the air outlet pipe conforms to
the technical characteristics of the appliance.
Do not use air outlet tubes of different sizes or
materials, as they may cause faults.

HOW TO USE

USE:
- Unwind the cable completely before plugging in.
- Plug the appliance into the mains.
- Orient the appliance to direct the air flow to the
desired direction.
- Switch the appliance on by pressing the On /
Off button (A).
- Select the desired mode (D).
- Select desired speed (E).
TIMER FUNCTION:
SETTING THE TIMER ON:
- When the air conditioner is off, press the "F"
button and select the desired power-on time
through the temperature and time adjustment
buttons.
- The on time can be set up to 24 hours.
- The programmed time or remaining time will
appear in the display (G).
SETTING THE TIMER OFF:
- When the air conditioner is on, press the
"F" button and select the desired sleep time
through the temperature and time adjustment
buttons.
- The shut-off time can be set up to 24 hours.
- The programmed time or remaining time will
appear in the display (G).
COLD MODE:
- Press mode (D) to select cold mode, the cold
mode indicator will light up (e).
- Press + or - to set the temperature in a range of
16 ~ 31 ° C (61 ~ 88 ° F).
- Pressing + or - once, the temperature will
increase or decrease gradually.
- Press (E) to select high or low fan speed.
HEATING OPERATION *
- Press the "D" button till the "h" icon appears.
- Press the "TEMP+"or" TEMP-" button to select a
desired room temperature (16 ºC - 31 ºC)
- Press the "E" button to select wind speed.
(*) Only available in AC3100RVKT model
FAN MODE:
- Press mode (D) to select the fan mode and the
fan indicator will light up. Power (g) power to
increase or decrease power speed.
DEHUMIDIFIER MODE:
- Press (D) to select the mode
- Dehumidification mode indicator, and the dehu-
midification mode indicator will light up (f).
COMPRESSOR PROTECTION:
- Three minutes after pressing on / restarting, the
compressor will start to operate.
PROTECTION OF THE WATER TANK:
- When the water level in the lower water plate is
below the warning level, the appliance will notify
you automatically.
- Please pour the water in the machine accord-
ing to the instructions in the chapter "water
drainage".
WATER DRAINAGE:
- When the inside of the water tank is full, the
indicator will light up on the display.
- The device enters the standby mode.
- Remove the plug to remove the water, turn
the machine off and on again, the machine will
operate normally.
- This model has a self-evaporating function, in
the cold mode, please do not make continuous
drains to get a greater effect of cold.
ONCE THE APPLIANCE HAS BEEN USED:
- Stop the appliance by pressing button (A) on/off
- Unplug the appliance from the mains.
- Unplug the appliance from the mains and allow
it to cool down before starting any cleaning
operation.
- Clean the electrical assembly and the mains
plug with a damp cloth and dry them after-
wards. NEVER SUBMIT THEM IN WATER OR
ANY OTHER LIQUID.