Assembling The Accessories - Steam+Vacuum Extension Tubes; Connecting The Accessories - POLTI EcoSteamVac DUAL Manual De Instrucciones

ASSEMBLING THE ACCESSORIES
STEAM + VACUUM EXTENSION TUBES
♦ Connect the two extension tubes together (B and B1) paying attention to the direction indicated
by the arrows.
♦ Hook both extension tubes B and B1 to the connecting accessories (A1) of the flexible hose
(A).
The appliance is equipped with a parking system (14) on which it is possible, when you have
finished using them, to replace the extension tube accessory (B1). Incorrect assembly of the two
parts, (B) and (B1), will not allow this feature to be used. The parking system (14) allows you to fa-
sten the tube (B1) with or without the brush assembled onto the appliance body. To connect the
tube (B1) to the appliance, slide the hook located on the tube into the accessories storage on the
appliance (Fig. 8).

CONNECTING THE ACCESSORIES

All the EcoSteamVac Dual accessories can be connected directly to the accessories (A1) or to the
extension tubes (B or B1), previously assembled.
To connect the specific accessories for the vacuum and steam features (B-B1-C-D-E) proceed as
follows:
♦ Move the locknut (B2) of the accessory, if present, to the OPEN position (Fig. A1).
♦ Attach the desired accessory to the handle.
♦ Move the accessory locknut (B2) to the CLOSED position (Fig. A2).
♦ Check that it is firmly connected.
♦ There is also a lock button on the steam-vacuum extension tubes - B and B1: proceed as
above for the accessories, releasing the tubes by sliding the button as far as the lock position
(Fig. A3).
Fig. A1
♦ To connect the special accessories only for vacuum (E2-F-G-H-L) it is only necessary to attach
them without coupling them to the locknut.
To connect the steam lance (E1) with the steam concentrator (E), just screw it on. The same ope-
ration can be carried out for the colored brushes (E3), which can in turn be screwed onto the steam
concentrator (E) and onto the steam crevice tool (E1). The different colors allow you to always use
the same brush for the same surface.
Before connecting the steam lance with the steam concentrator the steam function must be disa-
bled by pressing the safety button (A3) to prevent the accidental release of steam.
PARKING SYSTEM
Fig. A2
20
Fig. A3