Control Panel Guide - Dri-Eaz Revolution LGR F413-115V El Manual Del Propietario

Ocultar thumbs Ver también para Revolution LGR F413-115V:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Note that only menu items followed by a greater-than
symbol ( > ) may be adjusted.
All settings and modes are discussed in detail in Control
Panel Guide, below.
Error messages
If the Revolution onboard diagnostics discover a prob-
lem, the unit will display an error message. See "System
Messages" for an explanation of each message.

Control Panel Guide

ON/OFF. Press to turn the unit on or off. When the
machine is turned on, the display normally reads
PLEASE WAIT COMP. DELAY and performs a numeral
countdown for a maximum of 60 seconds to 0. This de-
lay allows time for refrigerant pressures to equalize for
easier starting. Once the unit completes the compressor
delay, the display shows UNIT ON XX HRS and cycles
between INLET XX°F and INLET XX%. NOTE: If no
compressor delay countdown is displayed, a delay is not
CONTROL PANEL
DISPLAY
ON/OFF
DISPLAY
MENU
ON/OFF
DISPLAY MENU
MENU SELECTION /
UP KEY
PURGE PUMP
necessary and the machine will begin operation immedi-
ately.
DISPLAY MENU. Press to cycle through the display
of additional dehumidifier conditions and User Settings.
To return to the main menu, press the ON/OFF key
once.
MENU SELECTION. Press to change the values of
the "User Defined" settings. The MENU SELECTION
07-01839C F413-115V
PURGE PUMP
MENU SELECTION /
UP KEY
Press and release to turn unit on
or off.
Press to select next item in
menu. Menu item will show in
display.
Press to toggle or select values
in menu displayed.
Press and release to start purge.
Display will count down sec-
onds remaining until purge is
complete.
key acts as the UP key for adjusting the setpoint for Hu-
midistat mode operation. See User Settings Menu (be-
low) for details.
PURGE. Press to empty water from the condensate
pump reservoir. The display will read PUMP PURGING
with a numeral countdown. NOTE: During normal opera-
tion, the pump purges automatically.
Changing settings and viewing system information
Display setting changes and system information can be
accessed by pressing
of the key will display the next parameter (see list be-
low). When you reach the parameter you wish to adjust,
press
MENU SELECTION to increase the value.
Press
DISPLAY MENU again to accept the setting
and re-start the display cycle.
Note that only menu items followed by a greater-than
symbol ( > ) may be adjusted.
3
DISPLAY MENU. Each press
Dri-Eaz Products, Inc.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Revolution lgr f413Revolution lgrF413

Tabla de contenido