About 3M™ High Air Flow Filters - Dri-Eaz Revolution LGR F413-115V El Manual Del Propietario

Ocultar thumbs Ver también para Revolution LGR F413-115V:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

cloth to remove any debris. Take care not to damage
any interior components.
To maintain appearance, wipe interior and exterior sur-
faces with a damp cloth. For deep cleaning and a last-
ing, protective shine, use an automotive interior cleaner.
As Needed
Clean pump check valve and basin. If the unit displays
the message "ER9 PUMP BLOCKED PUMP & HOSE",
the pump check valve and pump basin may need to be
cleaned. Remove grills and cover as shown in Fig. B.
Remove screws from pump base and lift out pump. Wipe
out pump basin with a damp cloth. Inspect the pump
base for build-up of debris and clean if needed. Un-
thread barbed fitting with check valve and rinse fitting
and check valve with clean water. Reinstall check valve
into barbed fitting and install the barbed fitting into pump.
Do not overtighten. Reinstall pump on base. Reinstall
cover and grills.
Clean coils. With the cover removed, inspect both coils.
If excessive dust and debris is present, vacuum thor-
oughly and/or clean with coil cleaner.
ABOUT 3M™ HIGH AIR FLOW FILTERS
HAF filters from 3M provide superior particle retention, resist microbial growth on filter surfaces and allow for maximum
airflow throughout the filter loading cycle. Follow these guidelines to ensure maximum protection for equipment, technicians
and the job site:
Replace the HAF filter whenever it has been vacuumed clean and reused three times. HAF filters lose their effectiveness after
three uses.
Replace the HAF filter whenever it has been used on a mold remediation job or otherwise exposed to potentially dangerous
contaminants. Continued use of a contaminated filter risks the spread of contamination.
Do not wash or apply any liquids to the HAF filter. Exposure to liquids will reduce the effectiveness of the electrostatic material.
Do not operate without the HAF filter in place. Do not operate the unit with any other filter type. Incorrect filtration will reduce
unit efficiency and can cause damage to the unit.
07-01839C F413-115V
Fig. B: Disassembly for Cleaning
Remove the 4 screws
from housing and 2
top screws each from
inlet and outlet grills
and lift off cover.
6
Dri-Eaz Products, Inc.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Revolution lgr f413Revolution lgrF413

Tabla de contenido