Dri-Eaz LGR i-Serie Manual Del Usuario

Featuring integrated sensors and remote monitoring capability
The Dri-Eaz® LGR i-Series dehumidifiers reduce humidity in enclosed structural
environments by removing water vapor from the air. The i-Series product line is engineered
to be rugged, durable and highly portable, making them ideally suited for water damage
restoration, structural drying, construction, and other applications requiring temporary,
high-performance dehumidification.
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
SAFETY INSTRUCTIONS
WARNING
WARNING! Do not alter or modify your Dri-Eaz
product in any way. Use only replacement parts
authorized by Dri-Eaz Products, Inc. Modifications or
use of unapproved parts could create a hazard and
will void your warranty. Contact your authorized Dri-
Eaz distributor for assistance.
WARNING! Electric shock hazard, rotating fan, hot
surface hazards. Unplug unit before opening cover
for cleaning or servicing. Unit must be grounded.
• Inspect the power cord before use. If cord is
damaged, do not use. Always grasp the plug (not
the cord) to unplug.
• Insert three-prong plug on power cord into a
matching electrically grounded outlet. Do not use
adapter. Never cut off third prong. Do not use an
extension cord.
IMPORTANT
To help prevent drip tray overflow after using the dehumidifier, always purge the unit before moving.
1. Turn the unit off and allow the plugged in dehumidifier to rest for 10 minutes.
2. Press the PURGE key and while the purge pump is operating, tip the unit back approximately 45° and hold the
unit in place until the purge cycle is complete. The manual purge cycle lasts approximately 10 seconds.
3. Return the unit to the upright position and press PURGE one more time to empty the pump.
Remove the dehumidifier promptly from the job site once these steps have been completed.
07-01674G 2013-01 Warranty 07-00420
Owner's Manual
LGR 2800i Portable Dehumidifier (F410)
LGR 3500i Portable Dehumidifier (F411)
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA 98233
Phone: 800-932-3030 Fax: 360-757-7950 www.dri-eaz.com
Patents: http://www.LBpatents.com
• The unit must be operated on a 115V/60 Hz circuit
protected by a Ground Fault Circuit Interrupter
(GFCI) device.
• Keep motor and wiring dry.
• Do not attempt to repair the unit. For Authorized
Service Centers, call Dri–Eaz at 800-932-3030.
BEFORE YOU BEGIN
Unpacking your unit
Retain all packing material and boxes for possible
equipment returns. Find and retain the AA batteries,
which must be installed before using the unit.
Installing the sensor batteries
Two AA batteries are shipped with the 2800i and 3500i
to provide power to the built-in HygroTrac® wireless
transmitter when the unit is not connected to AC power.
The battery compartment is located directly under the
power cord socket on the back of the unit (see Figure C).
Use a flat-blade screwdriver to turn the battery
compartment cover 90° counter-clockwise and remove
the cover. Insert the batteries with the negative terminal
in first. After inserting the batteries, secure the cover by
pressing it in with the screwdriver and turning it 90°
clockwise.
Warranty registration Visit warranty.drieaz.com to
register your purchase. Registration allows us to better
assist you with using, maintaining or servicing your
equipment, as well as to contact you in case we have
1 Dri-Eaz Products, Inc.