Atmor Thermo Boost 10.5 kW Guía De Instalación Y Funcionamiento página 14

Care and Maintenance
Stopping and restarting the system due to servicing, water
stoppage, or other interruptions of operation
01
Press the power switch to
03
the OFF position.
Perform the maintenance
or servicing tasks.
05
Reconnect power to
the unit at the circuit
breaker on the main
electrical panel.
Press the power switch
to the ON position.
13
02
Shut off all power to the unit at the
circuit breaker on the main electrical
panel.
04
Open one or more hot water faucets and
allow water to run through the unit for
several minutes to purge any air from
the heater and water lines.
This step must be performed
before turning on power to the
heater.
Failure to perform this step
may cause permanent damage
to the heating elements.
06
With water running through the unit,
check and reset the temperature if
necessary.
The recommended temperature setting
is 118°F (48°C).