Kingston DataTraveler 4000 G2 Manual Del Usuario página 4

Figure 1.1 – Recommended Usage
*Note: See 'Drive Letter Conflict' on page 26.
Setup (Windows Environment)
1. Insert the DT4000 G2 into an available USB port
on your notebook or desktop and wait for
Windows to detect it.
• Windows Vista users will receive a device
driver notification as seen in
• Windows 7 users will receive a device driver
notification as seen in
Once the new hardware detection is complete,
Windows will prompt you to begin the initialisation
process.
• Windows Vista users will see an AutoPlay
window similar to the one in
• Windows 7 users will see an AutoPlay window
similar to the one in
2. Select the option '
If Windows does not AutoPlay, you can browse to
the CD-ROM partition (
execute the DT4000 G2_Launcher program. This
will also start the initialisation process.
Document No. 48000127-001.A04
Figure 2.2
.
Figure 2.2
Figure 2.3
.
Figure 2.3
Run DT4000 G2_Launcher.exe
) and manually
Figure 2.4
DataTraveler
Figure 1.2 – Not Recommended
.
Figure 2.1 – Found New Hardware
Figure 2.2 – Device Driver Installation
.
'.
®
4000 G2
(Windows Vista)
(Windows 7)
Page 3 of 27