Settings Screen - Pentair FOLEO 5800 XTR Manual Del Usuario

Note

If no assistance name and phone as been set, "for service or assistance: please contact your local
water professional" will be displayed.
Note

The Assistance screen is also displayed automatically when the system reaches the programmed
assistance interval.
5.4.

Settings screen

The settings screen allows you to change basic controller settings including time of regeneration and water hardness. These
settings improve the operational efficiency of the system and can be adjusted independently from other controller settings
without needing to enter master settings.
Note

Settings can not be accessed during a regeneration. If a regeneration has to start while in the settings
menu, it will not start until exit the menu.
From the home screen, press the settings button
day override/time-driven
Press
a new regeneration will automatically be run whether one is scheduled or not.
regen. time
Press and use the arrows
hardness
Press and use the arrows
incoming untreated water supply.
6 . Startup
1. Fill the brine tank in the cabinet with salt.
2. Adjust the safety brine valve in the brine well to make sure the overflow elbow is installed above the float level.
3. After the softener has been running a few minutes in service, proceed to hardness test on outlet water to make sure the
water is treated as per requirements, and eventually adjust the mixing device accordingly.
Note

Pentair advise to set a residual hardness between 50 and 100 mg/L of CaC0
Ref. MKT-UG-038 / D - 15.11.2019
to access the settings screen.
Settings
day override/
time-driven
regen. time
hardness
and use the arrows
to adjust the time of day when an automatic regeneration cycle will begin.
to adjust the hardness setting. This value should match the hardness of the
1 d
02:00 am
300 mg/L
to adjust the number of days since last regeneration in which
User Guide Foleo
.
3
15 / 116