Publicidad
Idiomas disponibles
Idiomas disponibles
5. Insert the 8 supports into the 8 support holes.
6. Place the center plate onto the supports, pressing firmly
to ensure full installation.
7. Place the pump into the basin.
8. Cut a length of tubing long enough to reach from the
bottom of the basin to the top of the water feature.
9. Run the tubing through the center hole in the top of the
center plate and connect it to the pump outlet fitting.
Top Plate
Plaques supérieures
Placas superiores
Central Support
Support Central
Soporte central
Tubing cut-outs
Découpes pour tuyauterie
Recortes para el tubo
Fig. 1 - DFB30
Center hole
Trou central
Orificio central
Tubing cut-outs
Découpes pour tuyauterie
Recortes para el tubo
Cord cut-out
Découpe pour cordon
d'alimentation
Recorte para el cable
Fig. 2 - DFB36
2
10. Install the four top plates. On the side nearest the power
11. Install the four access covers, ensuring that the cut-out
12. To complete the installation, please follow the
Cord gap
Espace prévu pour le cordon
d'alimentation
Access cover
Espacio para el cable
Couvercles d´accés
Cubierta de acceso
Cord cut-out
Orificio central
Découpes pour cordon
d´alimentation
Recortes para el cable
Basin
Support holes
Cuvette
Trous pour supports
Cubeta
Orificios de soporte
Cord cut-out
Découpe pour cordon
Top plates (6)
d'alimentation
Plaques supérieures (6)
Recorte para el cable
Placas superiores (6)
Support
Support
Soporte
Basin
Cuvette
Cubeta
Receptacle
Réceptacle
Receptáculo
supply, run the pump power cord out the cord gap,
under the edge of the top plate, and through the cord
cut-out.
in each faces outward.
instructions provided with the water feature & pump you
purchased.
Center hole
Trou central
Access cover
Lip
Fig. 3 - DFB44
Access cover (4)
Couvercles d'accès (4)
Cubierta de acceso (4)
Top plates (4)
Plaques supérieures (4)
Placas superiores (4)
Edge
Bord
Borde
Center plate
Plaque centrale
Placa central
Supports (8)
Supports (8)
Soportes (8)
Basin
Cuvette
Cubeta
Publicidad
