HP LaserJet 1022nw Guida Rapida página 24

3. Turn the printer on.
4. Print a configuration page to obtain additional information about the network
If the IP address on the configuration page is 0.0.0.0, then wait a few minutes and then print
NOTE
the configuration page again. Do this until the IP address is not 0.0.0.0. The printer will have
an IP address based on your personal network configuration. For example, the IP address
might look like 192.168.x.y, where the x and y can be any numbers between 0 and 255.
5. Insert the CD into a computer that is linked to the network. Follow the on-screen
6. After the installation is complete, make sure that the network cable is disconnected.
18 Chapter 2 Setting up the printer
The green light on the network port illuminates.
configuration settings, such as the IP address. When the printer is in the Ready state,
press and hold the G
O
installation prompts. In the Model dialog box, select the HP LaserJet 1022nw. In the
Printer Connection dialog box, select the Connected via wireless option.
button until the Ready light starts blinking.
ENWW