HP LaserJet 1022nw Guida Rapida página 27

The printer must first be setup in ad-hoc mode (peer-to-peer) before it can join an
NOTE
infrastructure mode (network).
1. Setting up the Macintosh
a. Start the Macintosh in OS X 10.2 or higher (not supported in v10.1).
b. Plug the power cord into the printer and then plug the cord into the power outlet.
c. Turn the printer on.
d. Print a configuration page to obtain information about the network configuration
e. On the Macintosh, open System Preferences, and then click the Network icon.
f.
g. Type in a name for the new location, such as HP Setup, and then click OK.
h. Select Show, and then Network Port Configurations. Make sure Internal Modem
i.
j.
k. Select hpsetup from the drop-down menu.
l.
ENWW
settings. When the printer is in the Ready state, press and hold the
the Ready light starts blinking.
From the Location Selector, select New Location.
and Built-In Ethernet are not selected.
Set Show: to AirPort.
Click Join a specific network.
Click on the TCP/IP tab, and select Manually from the Configure drop-down menu.
Connect the printer to a wireless only network
G button until
O
21