Uat-600-T Transmitter Controls And Display - Amprobe UAT-600 Serie Manual De Usuario

Depth Measurement Related Alerts
These alerts are associated with depth measurements and only appear within the depth pop-up screen section.
Depth Related Alerts
Signal Abnormal
Overhead Signal
Shallow Utility

2.4 UAT-600-T Transmitter Controls and Display

Transmitter Controls
mA
1
2
3
8kHz
33kHz
50Hz
Radio
Not possible to compute depth because the signal is too noisy,
too weak or too strong.
Not possible to compute depth because of a strong signal
radiating from above (i.e., an overhead cable).
The unit has detected a shallow utility (less than 4 inches).
Caution is required when excavating.
0
mA
ENTER
5
4
457
1
Display
2 Power ON/OFF : press for 2 seconds to turn the
Transmitter ON/OFF. Indication shows up on the screen.
3
Up/Down ( / multifunction buttons): increase
or decrease signal strength on main screen, up/down
selection of functions in menu screen; Increase/decreases
volume and brightness in submenu screens.
4
Frequency Selection (
between available frequency options:
8 kHz 8 kHz Active mode
33 kHz 33 kHz Active mode
A-Low A-Frame mode low signal
A-Hi A-Frame mode high signal
5 ENTER/MENU: Press momentarily to enter Receiver
settings menu.
8
): press momentarily to toggle