Enerpac 22 Serie Instrucciones página 3

MOUNTING SPECIFICATIONS
Mounting Threaded Body Cylinders
Threaded body cylinders can be threaded into a tapped hole, secured to the fixture using
a mounting flange, threaded into the fixture and secured with a jam nut, or mounted
through a clearance hole and secured with jam nuts. See illustrations below.
When a threaded body pull cylinder is being installed in a fixture, the thread engagement
should be no less than the thread engagement for the standard Enerpac mounting flange.
If a cylinder is being mounted using just the lower portion of the threads, the engagement
should be increased for additional support. See table below for minimum thread
engagement.
Cylinder Capacity
2,2 kN
5,6 kN
9 kN
35 kN
threaded into fixture
oil connection
jam nut
500 lb
1250 lb
2000 lb
7900 lb
mounting flange
oil connection
jam nuts
Figure 1
Minimum Thread Engagement
13 mm
13 mm
16 mm
30 mm
3
.50"
.50"
.63"
1.25"