Tornado Pac-Vac 6 Aircomfort Manual De Operaciones Y Mantenimiento página 7

OPERATION INSTRUCTIONS
Please read the following operating instructions carefully. They will help you to get the best
performance from this professional quality vacuum cleaner and to maintain it in optimum condition.
Follow these simple steps for easy and effective operation of the Backpack vacuum.
Open the lid and ensure that the cloth bag is correctly located and the flexible ring provides a proper
seal when the lid is closed. For optimum performance, filtration and maximum hygiene, it is advisable
to use a paper vacuum bag in addition to the standard cloth bag.
If a paper vacuum bag is used, simply insert it into the cloth bag, making sure that the cardboard disk
is centered on the flexible sealing ring. When you replace the lid, the short nozzle in the center of the
lid will be forced into the central hole of the cardboard disk of the paper vacuum bag thus providing
a tight seal. Make sure the paper vacuum bag is tightly secured over the short nozzle before
vacuuming.
Lock the lid down with the two latches. Always ensure that the cloth vacuum bag is empty and the
paper bag is no more than ½ full before vacuuming. The Backpack vacuum has been fitted with
a thermal overload switch to protect the motor against damage should the airflow be blocked for
extended periods. This may occur if the vacuum bag is overfull, the cloth filter bag is clogged or if
the vacuum hose or exhaust is blocked. The vacuum motor will stop before it can get too hot. If
this happens, empty and thoroughly clean the vacuum bag and HEPA filter or free any blockage and
ensure that adequate airflow is restored. After the motor has cooled to a safe operating temperature,
locate the thermal reset switch on the bottom of the unit and push it back in. There will be a slight
audible click. Now the motor will restart.
1. The vacuum hose is fitted into the cuff in the lid. It should not be necessary to remove the
hose in normal operation.
2. Place the Backpack vacuum on your back, adjust the shoulder straps until you feel comfortable
and then tighten the waist belt. The Backpack vacuum is designed to ride higher on your back
for maximum comfort.
3. Plug the cord into a 110 volt, grounded outlet. Always unwind the cord completely before
vacuuming. It is important to maintain the power cord in good condition. This unit ships with
a 50' 16/3 SJT power cord. Use care when pulling the cord around sharp edges and through
doorways.
Never operate the Backpack vacuum if the power cord is damaged in any way.
4. Attach the extension wand to the hose and fit the floor tool or any of the other vacuuming
accessories on the wand.
5. Turn the vacuum on. The toggle switch is located on the switch box. The switch box is affixed
to the waist belt.
6. After you finish cleaning, turn off the main power switch and unplug the cord from the wall
outlet. Then starting from the Backpack vacuum, wrap up the cord to store. Be careful not to
pull or yank on the vacuum cleaner's power cord.
7