Important Safety Instructions; Ups Location Warnings - Tripp-Lite SmartPro SMART1200LCD Manual Del Propietário

Important Safety Instructions

SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed during the
installation, operation and storage of this product. Failure to heed these warnings
may affect your warranty.

UPS Location Warnings

• Install your UPS indoors, away from excess moisture or heat, conductive contaminants,
dust or direct sunlight.
• For best performance, keep the indoor temperature between 32º F and 104º F
(0º C and 40º C).
• Leave adequate space around all sides of the UPS for proper ventilation.
• Do not mount unit with its front or rear panel facing down (at any angle). Mounting
in this manner will seriously inhibit the unit's internal cooling, eventually causing
product damage not covered under warranty.
UPS Connection Warnings
• Connect your UPS directly to a properly grounded AC power outlet. Do not plug the UPS
into itself; this will damage the UPS.
• Do not modify the UPS's plug, and do not use an adapter that would eliminate the UPS's
ground connection.
• Do not use extension cords to connect the UPS to an AC outlet.
• If the UPS receives power from a motor-powered AC generator, the generator must provide
clean, filtered, computer-grade output.
• The mains socket outlet that supplies the UPS should be easily accessible and located
near the UPS.
• The building installation provides short circuit back-up protection.
Circuit Breaker
EMI Filter
AC In
Surge Protection
AC Out
USB Com Port
Serial Com Port
Teleprotect Circuit
*If applicable
17-02-143-9336B5.indb 2
Cut Relay
Boost 1 Relay
Line Cutoff Relay
LCD Display, Switches
Inverter
Transformer
Charger
Control
2
External Battery
Connector *
+
Internal
Battery
3/14/2017 2:03:49 PM