Brita FF-100 Guia Del Usuario página 11

Performance testing conducted by NSF International. This system has been tested according to NSF/ANSI 42 and 53 for reduction of the
substances listed. The concentration of each of the indicated substances in water entering the systems was reduced to a concentration
less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42 and 53.
System tested at 60 psig (414 kPa) using a minimum flow rate of 0.58 gpm (2.19 L/min).
Testing was performed under standard laboratory conditions. The contaminants or other substances removed or reduced by this water
treatment system are not necessarily in all users' water. Filter performance may vary based on local water conditions.
The Brita® Faucet Filtration System is not intended to purify water. Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters
that may contain filterable cysts. Individuals requiring water of special microbiological purity should follow the advice of their doctor or
local health officials regarding the use and consumption of their tap water and Brita water.
Brita® Faucet Filtration System Specifications
Capacity: Service Flow Rate:
100 gallons 0.58 gpm
(378 liters) (2.19 L/min)
Please refer elsewhere in this User's Guide for the proper installation, conditioning, use and care requirements and an explanation of
how the filter replacement indicator functions. Maintenance according to the manufacturer's instructions is essential for proper filter
performance. Filter life should not exceed 100 gallons. If a decrease in flow rate is noticed, replace the filter earlier. Replacement filters
(model FR-200) are available in one-, two- and four-packs with an approximate retail price of US$15 per filter/CAN$18 per filter.
The Brita® Faucet Filtration System has been tested and certified by NSF International against NSF/ANSI
Standards 42 and 53 for the reduction of the claims specified on the Performance Data Sheet.
The Brita® Faucet Filtration System has been tested and certified by the WQA against NSF/ANSI Standards 42
and 53 for the reduction of the claims specified on the Performance Data Sheet.
Distributed in U.S.A. for: Brita LP, 1221 Broadway, Oakland, CA 94612; 1-800-242-7482
Distributed in Canada by: Brita Canada Corporation, 150 Biscayne Crescent, Brampton, ON L6W 4V3; 1-800-387-6940
Working Pressures (min./max.):
20 psig/100 psig
(138 kPa/689 kPa)
(1.4 kg/cm /7.0 kg/cm )
2 2
Model FF-100 with Filter FR-200
Filtered Water
Temperature (min./max.):
34°F/100°F (1°C/38°C)
9
Electrical Requirements:
None