Installation (Tig) - Truper SOIN-120/160 Instrucciones De Uso

TIG Connection
• This inverter welder can also be used to TIG welding. It is a high-quality soldering with non- consumable tungsten electrodes
and arc protected by inert gas like Argon or Helium.
• TIG welding is ideal for welding stainless steel, iron and copper.
• For this process, you will require a AN-GRUPO1 torch and a protection gas tank or can, not included.
• Press the lower arrow of the process selector, so that the welder works in TIG (Tungsten electrode) mode.
NOTE The lower led of the selector will turn on.
• The connection shall be direct polarity:
• Connect the grounding clamp cable to the positive
(+) clamping screw outlet in the welder and the
grounding clamp to the work piece.
• Connect the torch cable (A) to the welder
negative (-) clamping screw outlet.
• Connect the torch gas inlet (B) to the
protection gas regulator outlet valve (C).
• Turn the torch valve (D) to open the gas
until getting an approximate flow in
L/min of 6 times the electrode diameter.
• To start the arc, support the nozzle in an angle onto the
work piece (1).
• Raise the torch without separating the nozzle from the
work piece to bring over the electrode to the work piece (2).
• When the electric arc starts lift the torch so that the
electrode tip is 0,08" away from the work piece (3). Start
soldering.
• It is recommended to keep the electrode 90° in the
vertical during the welding process
to guarantee the protection of the
gas.
8
ENGLISH
Installation
Led
D
B
1
C
2
(TIG)
A
3