Adjusting Loudness; Using Subwoofer Output; Adjusting Subwoofer Settings - Pioneer DEH-P4050UB Operación Manual

Section
03 Audio Adjustments
4 Turn MULTI-CONTROL to adjust the se-
lected segement.
Band
LOW (low)—MID (mid)—HI (high)
Frequency
Low: 40HZ—80HZ—100HZ—160HZ
Mid: 200HZ—500HZ—1KHZ—2KHZ
High: 3KHZ—8KHZ—10KHZ—12KHZ
Q factor
2N—1N—1W—2W
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
Note
A separate CUSTOM curve can be created for
each source. (The built-in CD player and the
multi-CD player are set to the same equalizer ad-
justment setting automatically.) If you make ad-
justments, the equalizer curve settings are
memorized in CUSTOM.

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Use MULTI-CONTROL to select
LOUDNESS.
2 Press MULTI-CONTROL to display the
setting mode.
3 Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
LOW (low)—MID (mid)—HIGH (high)—OFF
(off)
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
Also, phase can be selected between normal
and reverse.
24
En
1 Press SW to display the subwoofer set-
ting mode.
Press SW repeatedly to switch between the
subwoofer setting modes in the following
order.
SW SETTING 1 (subwoofer on/off setting) set-
ting mode—SW SETTING 2 (subwoofer set-
ting) setting mode
2 Select SW SETTING 1 setting mode.
3 Turn MULTI-CONTROL to select the de-
sired setting.
NORMAL (normal phase)—REV (reverse
phase)—OFF (subwoofer off)
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
Note
You can also switch to this setting mode in the
menu that appears by using MULTI-CONTROL.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
! When the subwoofer output is on, you can
select SW SETTING 2.
1 Press SW to display the subwoofer set-
ting mode.
Press SW repeatedly to switch between the
subwoofer setting modes in the following
order.
SW SETTING 1 (subwoofer on/off setting) set-
ting mode—SW SETTING 2 (subwoofer set-
ting) setting mode
2 Select SW SETTING 2 setting mode.
3 Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press MULTI-CONTROL repeatedly to switch
the segment in the following order:
Cut off frequency—Level