Installing Data Output Ports In The Scale - Sartorius YDO01SW-232 Instrucciones De Instalación

4 4

Installing Data Output Ports in the Scale

The interface module only has to be installed in the scale if the customer has not already
ordered the Signum scale factory-equipped with the desired data output port.
Notes
§ The interface module should only be installed by a trained and authorized Sartorius
technician.
§ IP65 protection:
Use the appropriate connecting cable with a cable gland designed for the interface
module in question (see "Accessories").
!
Disconnect the equipment from the electricity supply prior to commencing work.
!
Improper installation invalidates the applicable warranty.
!
Perform all installation work that affects the IP67 protection rating with extreme care.
§ Remove the 6 screws from the rear wall panel.
§ Carefully remove the rear wall panel. (The RS-232 interface is connected to the PCB
by a ribbon cable.)
§ Remove the standard RS-232 interface (including the accompanying PCB) from the rear
wall panel: remove the 2 screws from the connector mounting.